Keithley 6487 - Range Selection and Autoranging; Measurement Filters Overview

RS-232 settings ................................................................. 9-16
RS-232 connections .......................................................... 9-18
Error messages .................................................................. 9-19
10 Status Structure
Overview .................................................................................. 10-2
Clearing registers and queues ................................................... 10-4
Programming and reading registers ......................................... 10-5
Programming enable registers ........................................... 10-5
Reading registers ............................................................... 10-6
Status byte and service request (SRQ) ..................................... 10-7
Status byte register ............................................................ 10-7
Service request enable register .......................................... 10-8
Serial polling and SRQ ..................................................... 10-9
Status byte and service request commands ....................... 10-9
Status register sets .................................................................. 10-10
Register bit descriptions .................................................. 10-10
Queues .................................................................................... 10-17
Output queue ................................................................... 10-18
Error queue ..................................................................... 10-19
11 Common Commands
Common commands ................................................................ 11-2
12 SCPI Signal Oriented Measurement Commands
13 DISPlay, FORMat, and SYSTem
DISPlay subsystem .................................................................. 13-2
FORMat subsystem .................................................................. 13-4
SYSTem subsystem .................................................................. 13-9
14 SCPI Reference Tables
General notes ............................................................................ 14-2
15 Performance Verification
Introduction .............................................................................. 15-2
Verification test requirements .................................................. 15-2
Environmental conditions ................................................. 15-2
Warm-up period ................................................................ 15-3
Line power ........................................................................ 15-3
Recommended test equipment ................................................. 15-3
Verification limits ..................................................................... 15-5