Kemper 345plus - Ballasting Harvester; Adjusting Channel Width

Attaching to a Claas forage harvester
KM00321,0000204 -19-18AUG09-1/1
KM00321,0000544 -19-17JUN16-1/1
Ballasting Harvester
Before attaching the rotary harvesting unit, make sure
harvester is ballasted correctly.
IMPORTANT: Always refer to the information given
in Wheels and Ballast Section of the forage
harvester operator's manual.
Adjusting Channel Width
Before attaching the rotary harvesting unit to the forage
harvester, make sure that the feed plates (A) match with
the channel width of the forage harvester.
Preset channel width (X) for attaching the rotary harvesting
unit to a CLAAS forage harvester is 650 mm (2 ft. 1.59 in.).
A—Feed Plates
X—Preset Channel Width
KM285517 —UN—21NOV16KM285518 —UN—21NOV16
20-7
031519
PN=34