Attaching to a Claas forage harvester
KM00321,0000547 -19-20JUN16-1/1
Attaching to CLAAS Forage Harvesters
(Rotary Harvesting Units with Oscillating
Frame)
KM217981 —UN—15SEP14
KM1001090 —UN—04FEB10
1. Unlatch lever (A).
2. Drive the forage harvester close to the rotary
harvesting unit's frame until attaching straps (B)
protrude into consoles (D) of the attaching frame.
3. Remove pins (E) on both sides.
4. Lift feed roll housing (C) up until attaching straps (B)
of the rotary harvesting unit lie in the consoles (D).
5. Lock the rotary harvesting unit:
Secure upper bearing point by installing pin (E).
Lock rotary harvesting unit by engaging lever (A).
Secure lever (A) with quick-lock pin.
6. Lock jackstands (F) on the right and left side in the
highest position. To do this, pull out spring-loaded
pin (G) and let it re-engage when the jackstand is in
its final position.
A—Lever
B—Attaching Straps
C—Feed Roll Housing
D—Console
E—Pin
F— Jackstand
G—Pin
KM1002324 —UN—27JUN12KM217983 —UN—15SEP14KM217984 —UN—15SEP14
20-12
031519
PN=39
To Next Page
Loading...
