X8 MIG WELDER 2.5 Operation
If the WPS includes several passes, select the pass in Active pass. See Selecting WPS pass in
WPS view on page 128.
5.
Press a view button to leave the WPS view.
Note:
You can also change WPS or the pass in Channel view. See Selecting WPS or pass in
Channel view on page 130.
Selecting WPS pass in WPS view
Proceed as follows:
1.
Go to the View menu > WPS.
Control Pad shows the active WPS in the WPS view.
OPERATING MANUAL | EN 128
©
KEMPPI 2017 | 1817
To Next Page
Loading...
