X8 MIG WELDER 2.7 Maintenance
• Check and remove any spatter build-up from the nozzle.
• When you are not using the gun, keep it in the welding gun holder on the wire feeder.
Maintenance of Control Pad
Control Pad is water resistant and can be wiped clean with a moist cloth. Do not use detergents.
For repairs, contact Kemppi at www.kemppi.com or your dealer.
2.7.2 Periodic maintenance of power source and wire feeder
Caution:
Only qualified service personnel is allowed to carry out periodic maintenance.
OPERATING MANUAL | EN 161
©
KEMPPI 2017 | 1817
To Next Page
Loading...
Need help?
General
