X8 MIG WELDER 2.5 Operation
Press the Settings button to access the wire feeder settings. When the settings view is open, the
Settings button lights up orange.
Modify the parameters with the right knob. Press the green button in the center of the knob to
select and turn the right knob to adjust a parameter.
Table 5: Wire feeder settings
Trigger Change the welding gun trigger mode
(2T/4T).
WP Switch ON/OFF Switch the WP Switch feature ON or OFF.
Dynamics Adjust the dynamics setting for MIG, 1-MIG,
Pulse, DPulse and WiseThin+.
DPulse and WP Switch also have a
Dynamics2 setting for adjusting the
second level dynamics.
Hot start Switch the HotStart feature ON or OFF.
Crater fill Switch the crater fill feature ON or OFF.
Weld data Shows you the information on the latest
weld.
Press the green button on the right knob to
view more information.
Device information Shows you the serial number and software
versions of the welding system.
Press the green button on the right knob to
view more information.
Wireless devices Press the Connect button on the right to
set a wireless connection to Control Pad.
2.5.2 Preparing welding system for use
Switching on the welding system
To switch on the power source and wire feeder, turn the power source main switch to ON (I)
position. When the power source is on, the power indicator LED in the indicator panel is green.
OPERATING MANUAL | EN 108
©
KEMPPI 2017 | 1817
To Next Page
Loading...
Need help?
General
