X8 MIG WELDER 2.4 Installation
Measurement cable
Coolant input and output hoses
Earth return cable
2.4.5 Control Pad installation
This chapter describes the control pad installation.
For information on operating Control Pad, see Control Pad on page 94.
2.4.5.1 Wireless connection
Control Pad connects wirelessly to X8 Wire Feeder. If there are two wire feeders in the system,
choose which one to connect to. Control Pad can be connected to X8 Power Source in
applications where no wire feeder is needed, such as stick welding or gouging.
To set up a wired connection between Control Pad and the power source or the wire feeder, see
Wired connection on page 58.
If Control Pad is not connected, you see this info message on the display.
OPERATING MANUAL | EN 55
©
KEMPPI 2017 | 1817
To Next Page
Loading...
Need help?
General
