X8 MIG WELDER 2.4 Installation
Proceed as follows:
1.
To connect Control Pad wirelessly to a wire feeder or power source:
a) Press the wireless pairing button on the power source indicator panel.
The led on the power source begins to blink when it is searching for Control Pad.
The serial numbers of the nearby available wire feeders or power sources appear on
Control Pad's display.
Note:
When there are wire feeders connected to the welding system, pressing the
wireless pairing button allows you to connect Control Pad to a wire feeder. When
there are no wire feeders connected to the system, Control Pad allows you to
connect to a power source.
OPERATING MANUAL | EN 56
©
KEMPPI 2017 | 1817
To Next Page
Loading...
