Kemppi X8 - Operation; X8 MIG Welder Control Devices

X8 MIG WELDER 2.5 Operation
Double Wire Feeder Rotating Plate
The double wire feeder rotating plate allows the use of two wire feeders on one power source.
2.5 Operation
Follow these operating instructions carefully to have full advantage of your X8 MIG Welder and to
minimize the risk of malfunctions.
2.5.1 X8 MIG Welder control devices
Welding with X8 MIG Welder can be controlled through three different control panels, which offer
slightly different features for adjusting the welding parameters.
The actual features vary according to the functions and usability of the control panel.
OPERATING MANUAL | EN 93
©
KEMPPI 2017 | 1817