Kemppi X8 - Page 130

X8 MIG WELDER 2.5 Operation
4.
To change the pass selection, scroll to a pass in a list.
5.
Press the green button to select the pass and to return to the WPS View.
Note:
You can also select the WPS or pass in the Channel view. See Selecting WPS or pass
in Channel view on page 130.
Selecting WPS or pass in Channel view
Proceed as follows:
1.
Go to Channel view.
Channel displays the memory channel or WPS and the pass you are currently using.
OPERATING MANUAL | EN 130
©
KEMPPI 2017 | 1817