Kemppi X8 - Page 142

X8 MIG WELDER 2.5 Operation
Welding view, toggle between level 1 and level 2 by pressing the left Control Pad button. The
inactive power level is shown with a gray line on the wire feed speed diagram.
Figure 31: DPulse Welding view
To adjust the welding power / wire feed speed while welding, in the Control Pad's Welding view,
turn the left knob.
To fine tune voltage while welding, in the Control Pad's Welding view, turn the right knob.
When using DPulse, you can adjust the following parameters through Settings > Parameters:
• Wire Feed Speed: adjusts the wire feed speed for level 1.
• min: adjusts the minimum set value for wire feed speed
• max: adjusts the maximum set value for wire feed speed
• Fine tuning: adjusts the voltage (arc length).
• Dynamics: Adjusts the short circuit behavior. On the minus side, the arc is softer (less spatter).
On the plus side, the arc is harder (the arc is more stable).
• Pulse current %: -10...+15. Adjusts the pulse peak current. Use for controlling the droplet
detachment.
• StartPower: -30...+30. Adjusts the power level for arc ignition.
• StartLevel: -30...+30. Fine tunes the arc length for arc ignition.
• StopPower: -30...+30. Adjusts the power level for arc stop.
You can adjust the following parameters through Settings > DPulse:
OPERATING MANUAL | EN 142
©
KEMPPI 2017 | 1817