X8 MIG WELDER 2.5 Operation
Figure 36: WiseSteel Welding view
Note:
The wire feed speed / current indicator shows the arc range:
1. Short arc
2. Globular arc
3. Spray arc
The adjustment method is different for each range.
Introduction to WisePenetration+
In standard MIG/MAG welding, changes in stick-out length cause welding current to fluctuate.
WisePenetration+ maintains constant welding current by controlling the wire feed speed
according to the stick-out length. This ensures stable and effective penetration and prevents burn
through. WisePenetration+ also adjusts the voltage adaptively, which keeps the arc focused and
optimally short. WisePenetration+ enables welding with Reduced Gap Technolology (RGT) and is
compatible with 1-MIG and Pulse welding processes.
Using WisePenetration+
To take WisePenetration+ into use, select Settings > Wise features > WisePenetration+.
To adjust the welding current, in the Control Pad's Welding view, turn the left knob.
To fine tune heat output, in the Control Pad's Welding view, turn the right knob.
OPERATING MANUAL | EN 148
©
KEMPPI 2017 | 1817
To Next Page
Loading...
