Kenwood NX-5200K3 Function Reference

Lone Worker
Interval
Transmit (PTT)
Sounds the
Time
Duration of Lone
Lone Worker Tone
Emergency Mode
Worker Tone
AUX Port (except
PC Command
External PTT (Voice)) (Mobile only)
Figure 2-2 Lone Worker Mode
0
Exiting Lone Worker Mode
1
Do either of the following operations while the transceiver is in Lone Worker Mode:
0
Press the Lone Worker key.
0
Select a channel where Lone Worker is disabled.
0
Press the Menu key to enter Menu Mode, and select “Lone Worker” and then select “OFF”.
0
The “
” icon disappears and the transceiver exits Lone Worker Mode.
The
Key Beep B (2 beeps) sounds from the transceiver when the Lone
Worker key is pressed.
Menu Zone +
Zone 1
Channel 1
12 : 34
A
M
Note
0
If “Transmit/Receive Inhibit” is configured in Lone Worker Type, Lone Worker cannot be turned ON or OFF in Menu
Mode. (Refer to Lone Worker Type.)
0
Lone Worker cannot be activated while the transceiver is in the Stun state or while in Transceiver Password Mode.
0
For
Mobile, if the AUX Input port to which “Emergency” is assigned becomes active for the time configured in Emergency
Delay Time while the transceiver is in Lone Worker Mode, the transceiver enters Emergency Mode.
0
Lone Worker can be activated even if the Key Lock state is activated while the transceiver is in Lone Worker Mode.
0
If the transceiver migrates from Lone Worker Mode to Emergency Mode, the transceiver exits Emergency Mode if the
Emergency key is pressed for a length of time greater than the length of time configured in Hold Delay.
0
If a scan initiates while the transceiver is in Lone Worker Mode, the scan initiates with Lone Worker Mode enabled. If the
scan starts while the transceiver is in a mode other than Lone Worker mode, the scan starts with Lone Worker Mode
disabled.
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
0
Configuring Lone Worker (DMR Conventional) to be enabled or disabled (Personality) ( Transceiver Settings
> Personal > Personality > DMR Conventional > General)
0
Configuring Lone
Worker (DMR Conventional) to be enabled or disabled (Channel Edit) (
Transceiver Settings
> Zone/Channel > Channel Edit > DMR Conventional > General)
2 COMMUNICATIONS IN AN EMERGENCY
2.8 Placing the Transceiver in Emergency Mode Using the Lone Worker Function
DMR FUNC (K, F)/Ver 2.20 109
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English