Kenwood NX-5200K3 Function Reference

Scan is the function to check whether the transceiver receives a call from other transceivers.
The
transceiver sequentially searches for availability of signal on each channel, and the transceiver receives on the channel
where the signal is detected.
Three methods are available for Scan as shown below.
0
Single Scan
The transceiver scans target channels in the same zone.
0
List Scan
The transceiver scans the Zone-channel registered as a member in a Scan List.
0
Multi-Zone Scan
The transceiver scans all target channels in the target zones.
4.1
Starting the Scan
Scan can be started by one of the following methods:
0
Operating the PF Keys
0
Pressing the Scan key starts or stops scanning.
0
Pressing the Scan Normal key starts or stops scanning.
0
Even
if the Priority Channel is configured, pressing the Scan Normal key disables the Priority Channel and mandatorily
executes Non-Priority Scan.
0
Executing “Scan” or “Scan Normal” after pressing the Menu key to enter Menu Mode starts or stops scanning.
0
Lever switch operation
Operating the Lever switch to be in the position where “Scan” or “Scan Normal” is allocated starts scanning. Operating
the Lever switch to be in the position where “Scan” or “Scan Normal” is not allocated stops scanning.
0
Status changes of the AUX Input port (Mobile only)
When the AUX Input port where “Scan” is assigned goes low level, the scan starts. When the AUX Input port where
“Scan” is assigned goes high level, the scan stops.
0
Turning the transceiver on
If Power-on Scan is enabled, the scan starts when the transceiver is turned on. (Refer to Power-on Scan.)
0
Selecting a channel
The scan starts if a channel with Auto Scan enabled is selected. (Refer to Auto Scan.)
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
0
Allocating functions to the Lever
switch (
Transceiver Settings > Key Assignment > Top/Side)
0
Allocating functions to the AUX Input port (
Extended Function > AUX)
4 SCAN
4
SCAN
DMR FUNC (K, F)/Ver 2.20 134
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English