Kenwood NX-5200K3 Function Reference

3.8
Deleting the Encryption Key (Key Delete)
Key Delete is the function for deleting the Encryption Key that is configured using the Key Loader in the SCM or the
Encryption Key of Built-in DES and Enhanced Encryption.
The transceiver needs to enter Key Delete Mode in order to delete Encryption Key data using this function.
Pressing the Key Delete key places the transceiver in Key Delete Mode.
The
transceiver can also enter Key Delete Mode by pressing the Menu key to place the transceiver in Menu Mode and then
selecting “Key Delete”. (Refer to Common FUNC Using Menu Mode.)
Operating the transceiver
1
Press the Key Delete key.
Enters Key Delete Mode.
The following operations can also be used even if the transceiver enters Delete Mode by pressing the Menu key:
2
Press the [ ] key or [ ] key and then select a Multi-key from the Multi-Key List.
Refer to Common FUNC “Selecting or Clearing Data from a List” for
selection methods.
3
Press the Back ([ ]) or [ ] key.
The selected Multi-key is deleted.
12 : 34
A
M
Key Delete 05
CKR 03
CKR 04
CKR 05
DeleteExit
12 : 34
A
M
Key Delete 05
CKR 03
CKR 04
DeleteExit
Erased
Note
0
Pressing and holding either the Back ([O]) key or [#] key deletes all Multi-key data.
0
If the Encryption Key corresponding to the selected Multi-key is not configured on the SCM, or if the Encryption Key is
deleted from the SCM, “Erased” appears.
Configuration using KPG-D1/ D1N
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
3 COMMUNICATION SECURITY
3.8 Deleting the Encryption Key (Key Delete)
DMR FUNC (K, F)/Ver 2.20 128
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English