Kenwood NX-5200K3 Function Reference

4.3
Scan by Registering Multiple Target Channels for Scan in the
List (List Scan)
Using the List Scan enables the transceiver to scan the Zone-channels registered as a member in a Scan List.
If
a scan starts in a zone where “List” is configured in Scan Type or on a channel where a Scan List Number is configured,
List Scan is executed. Or, if the transceiver is in the zone where “List” is configured in Scan Type and migrates to the channel
where a Scan List Number is configured during the scan, List Scan is executed.
Operating the transceiver
1
Press the Scan key.
The scan starts after a Key Beep A (1 beep) sounds from the transceiver.
The “ ” icon appears and then Revert Channel is displayed.
If “Scan” Displayed is
enabled, “Scan nnn” (nnn indicates Scan List No.)
is displayed.
For portable transceivers, the LED light flashes according to the
configuration of Non-Priority Scan LED in the case of non-priority scan,
and according to the configuration of Priority Scan LED in the case of
priority scan.
Note
The transceiver behaves in the same manner even if the scan is started
by other method. (Refer to Starting the Scan.)
2
Press the Scan key during the scan.
The scan completes after a Key Beep B (2 beeps) sounds from the
transceiver and the “
” icon disappears.
Menu Zone +
Zone 1
Channel 1
12 : 34
A
M
Scan 128
Menu Zone +
Zone 1
Channel 1
12 : 34
A
M
Note
0
If Selected Channel Scan
is enabled, the selected channel can be scanned even if the channel is excluded from the
target channels for scan. (Refer to Selected Channel Scan.)
0
If another zone is selected during the List Scan, the transceiver starts the scan according to the configuration in Scan
Type of the selected zone.
4 SCAN
4.3 Scan by Registering Multiple Target Channels for Scan in the List (List Scan)
DMR FUNC (K, F)/Ver 2.20 137
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English