1.9
Common Functions for Data Communications
The following functions are used in common for data communications such as Status Call and Short Data Call:
0
Number of Retries
0
Transmit Busy Wait Time
0
Maximum ACK Wait Time
0
Preamble Length
Number of Retries
If the transceiver does not receive the acknowledgment after the transceiver sends data and the time configured for
Maximum ACK Wait Time elapses, the transceiver resends data. Number of Retries is the number of times for the
transceiver to resend data. A smaller number can be configured if there is good communicating conditions, and a larger
number can be configured if there are inferior communicating conditions.
Configuration using KPG-D1/ D1N
Configuring Number
of Retries (
Transceiver Settings > Personal > Personal Features > DMR Conventional > DMR
> Parameters)
Transmit Busy Wait Time
The transceiver confirms that the traffic channel is available before sending data and then starts sending data when the
channel is available. Transmit Busy Wait Time is the duration to wait for the traffic channel to become available.
A transmission is canceled when the channel is busy and the Transmit Busy Wait Time elapses.
Configuration using KPG-D1/ D1N
Configuring Transmit
Busy Wait Time (
Transceiver Settings > Personal > Personal Features > DMR Conventional
> DMR > Parameters)
Maximum ACK Wait Time
Maximum ACK Wait Time is the length of time that the transceiver stands by to receive the acknowledgment after the
transceiver sends data. If the transceiver does not receive the acknowledgment within the time configured for Maximum
ACK Wait Time, the transceiver resends data.
Configuration using KPG-D1/ D1N
Configuring Maximum
ACK Wait Time (
Transceiver Settings > Personal > Personal Features > DMR Conventional
> DMR > Parameters)
1 DMR CONVENTIONAL SYSTEM
1.9 Common Functions for Data Communications
DMR FUNC (K, F)/Ver 2.20 38
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
