1.13
Calling All Transceivers Having the Same Color Code
(Unaddressed Call)
Unaddressed Call is the function to initiate 2-way voice communication with multiple transceivers without specifying a group.
In a regular Group Call, the transceiver can communicate only with transceivers included in the Group ID specified.
Unaddressed Call can initiate a call to all transceivers having the same Color Code on the same channel.
Using
this function, such as during an emergency, the transceiver can initiate a call without distinguishing the group to share
information with the users of multiple groups.
To use this function, “Off” needs to be configured in Selcall on PTT of the channel to be used for an Unaddressed Call by
using KPG-D1/ D1N.
Note
0
The transceiver can send the ID of the transmitting transceiver from the communication port on the transceiver when
receiving an Unaddressed Call. (Refer to Sending the Received Unit ID from the Communication Port (Unit ID Serial
Output).)
0
An Unaddressed Call can also be initiated by receiving a PC command from the communication port. To use a PC
command,
“Data” or “Data + GPS Data Output” needs to be assigned to the communication port of the transceiver. (Refer
to Common FUNC Available Functions for COM Port.)
Configuration using KPG-D1/ D1N
0
Configuring Color Code
(Personality) (
Transceiver Settings > Personal > Personality > DMR Conventional >
DMR)
0
Configuring Color Code (Channel Edit) (
Transceiver Settings > Zone/Channel > Channel Edit > DMR
Conventional > DMR)
0
Configuring Selcall on PTT (Personality) ( Transceiver Settings > Personal > Personality > DMR Conventional
> DMR > Selcall on PTT)
0
Configuring Selcall on PTT (Channel Edit) ( Transceiver Settings > Zone/Channel > Channel Edit > DMR
Conventional > DMR > Selcall on PTT)
1 DMR CONVENTIONAL SYSTEM
1.13 Calling All Transceivers Having the Same Color Code (Unaddressed Call)
DMR FUNC (K, F)/Ver 2.20 59
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
