4.6
Transceiver Behavior during the Scan
This section describes various behaviors of the transceiver during the scan.
Note
The length of time from when the transceiver pauses the scan for transmission or reception until the transceiver resumes
the scan can be configured using Dropout Delay Time and Dwell Time. (Refer to Dropout Delay Time, Dwell Time.)
Transceiver Behavior When a Zone-channel Is Changed during the Scan
If a Zone-channel is changed manually during the scan, the transceiver pauses the scan on a new channel. After a second
elapses, the scan resumes.
If
a Zone-channel is changed manually while the scan pauses for reception, and if the channel where the scan is paused is
different from the selected channel, the scan pauses on the selected channel.
Reception during the Scan
The following are the reception behaviors during the scan.
If the Color Code and ID (Unaddress ID, Group ID, or Individual ID) received on each channel match the Color Code and
ID
(Unaddress ID, Group ID, or Individual ID) preconfigured for the transceiver, the transceiver pauses scanning. If the Color
Code or ID (Unaddress ID, Group ID, or Individual ID) does not match, Dropout Delay Time is activated. After the time
configured in Dropout Delay Time elapses, the transceiver resumes the scan.
4 SCAN
4.6 Transceiver Behavior during the Scan
DMR FUNC (K, F)/Ver 2.20 150
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
