Kenwood NX-5200K3 Function Reference

4.7
Scan Function
The following functions are relevant to the scan.
0
Scan Delete/Add
0
Zone Delete/Add
0
Revert Channel
0
Dropout Delay Time
0
Dwell Time
0
Channel Recall
0
Priority-channel Stop Tone
0
Auto Scan
0
Selected Channel Scan
0
Power-on Scan
0
Off-hook Scan (Mobile Only)
0
Scan Stop Tone
0
Preamble Length
Adding or Deleting a Channel to/from the Target Channels for Scan (Scan Delete/
Add)
Scan Delete/Add is the function to add a channel to be scanned to the Scan List or delete a channel to be scanned from
the Scan List.
This
function is used to reliably receive a call from a primary channel by deleting unnecessary channels to increase the scan
speed.
The following are the transceiver behavior:
0
When Scan is disabled
For a zone with “Single” or “Multi-Zone” configured in Scan Type:
Pressing the Scan Delete/Add key allows you to add the selected channel to the target channels for scan or delete
the selected channel from the target channel s for scan. The Scan Delete/Add information is retained in the transceiver.
For a zone with “List” configured in Scan Type:
Pressing the Scan Delete/Add key allows you to add the selected channel as a member to the Scan List configured
for the selected channel, or delete the channel from the Scan List configured for the selected channel. The Scan
Delete/Add information is retained in the transceiver.
0
When the scan is paused
For a zone with “Single” or “Multi-Zone” configured in Scan Type:
Pressing the Scan Delete/Add key allows you to add the selected channel temporarily to the target channels for scan
or delete the selected channel temporarily from the target channels for scan (Temporary Delete/ Add). This status is
retained until the scan is terminated by operations such as pressing the Scan key, and the status is cleared when the
scan completes.
For a zone with “List” configured in Scan Type:
Pressing the Scan Delete/Add key temporarily deletes a selected channel if it is registered in the members of Scan
List. Pressing the Scan Delete/Add key again restores it (Temporary Delete/ Add). This status is retained until the
scan is terminated by operations such as pressing the Scan key, and the status is cleared when the scan completes.
0
During the scan
Pressing the Scan Delete/Add key causes a Key-entry Error Tone (1 beep) to sound from the transceiver but the
transceiver does not respond at all.
4 SCAN
4.7 Scan Function
DMR FUNC (K, F)/Ver 2.20 151
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English