Kenwood NX-5200K3 Function Reference

4.4
Scanning All Target Zones for Scanning (Multi-Zone Scan)
In a DMR Conventional system, by using Multi-Zone Scan, the transceiver can scan all channels to be scanned in the target
zones.
If
a scan starts in the zone where “Multi-Zone” is configured in Scan Type, Multi-Zone Scan is executed. Or, if the transceiver
migrates during the scan to the zone where “Multi-Zone” is configured in Scan Type, Multi-Zone Scan is executed.
The target zone for scanning is either the zone with Zone Add enabled by using KPG-D1/ D1N or the zone with Zone
Add enabled by using the Zone Delete/Add key.
The target channel for scan is either the channel with Scan Add enabled by using KPG-D1/ D1N or the channel with Scan
Add enabled by using the Scan Delete/Add key.
Operating the transceiver
1
Press the Scan key.
The scan starts after a Key Beep A (1 beep) sounds from the transceiver.
The “ ” icon appears and then Revert Channel is displayed.
If “Scan” Displayed
is enabled, “Scan” is displayed.
For portable transceivers, the LED light flashes according to the
configuration of Non-Priority Scan LED in the case of non-priority scan,
and according to the configuration of Priority Scan LED in the case of
priority scan.
Note
The transceiver behaves in the same manner even if the scan is started
by other method. (Refer to Starting the Scan.)
2
Press the Scan key during the scan.
The scan completes after a Key Beep B (2 beeps) sounds from the
transceiver and the “ ” icon disappears.
Menu Zone +
Zone 1
Channel 1
12 : 34
A
M
Scan
Menu Zone +
Zone 1
Channel 1
12 : 34
A
M
Note
0
“Multi-Zone” can be configured in Scan Type only for the zones structured with the following systems:
0
System Type = Analog Conventional
0
System Type = P25 Conventional
0
System Type = NXDN Conventional
0
System Type = LTR Trunking
0
System Type = DMR Conventional
Even
if these systems exist in the same zone, “Multi-Zone” can be configured in Scan Type. In this case, “Single” can
also be configured in Scan Type, and starting Multi-Zone Scan can also scan the zones with “Single” configured in
Scan Type.
4 SCAN
4.4 Scanning All Target Zones for Scanning (Multi-Zone Scan)
DMR FUNC (K, F)/Ver 2.20 142
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English