EasyManuals Logo

Kenwood NX-5200K3 Function Reference

Kenwood NX-5200K3
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #186 background imageLoading...
Page #186 background image
A
Abbreviations Used in This Document viii
About Communication Security (Encryption) 2
About Copyright ix
About Examples of the Transceiver Display vii
About KPG-D1N x
About Multi RF Deck/ Multi Control Head xi
About Notations vi
About Options to Use the Functions Described
in This Document
xi
About Own ID 2
About System Type xi
About the Behavior of the Encryption Icon 123
About the Behavior When a Message
Requesting the Status Transmission Is
Received
44
About the Built-in GPS Receiver Unit xii
About the Notation of “Configuration Using KPG-
D1/ D1N”
x
About the Notation of the Supported Models vii
About the Programming Software x
About the SCM Communication Error Display 132
About the Slot Numbers (Slot Selection) 11
About the Zone-channel Format x
About This Manual v
About Trademarks and Patent Rights ix
Adding or Deleting a Channel to/from the Target
Channels for Scan (Scan Delete/Add)
151
Adding or Deleting a Zone to or from the Target
Zones for Scanning (Zone Delete/Add)
152
Applicable SCMs 124
Auto Reset Timer 3
Auto Scan 155
Automatically Transmitting and Receiving in
Emergency Mode
99
AUX Input Status Message (Mobile Only) 49
AUX Output Status Message (Mobile Only) 49
Available Calls 15
Avoiding Interference with Other
Communications (Busy Channel Lockout
(DMR))
7
Avoiding Receiving a Group Call during an
Incoming Individual Call (Ignore Group Call
during Individual Call)
35
B
Background Transmission 102
Base ID 48
BEEP LIST 166
Behavior in Asynchronous State 85
Behavior when Data Received Cannot be
Properly Decrypted
122
Built-in DES 125
C
Calling All Transceivers Having the Same Color
Code (Unaddressed Call)
59
Causing Transceivers Other than the
Transceiver of the Specified ID to Participate in
a Conversation (Open Voice Channel Mode)
57
Changing the Priority Channel 146
Changing the Scan List (Scan Program) 140
Channel Recall 154
Checking Whether Another Transceiver Is in
Operation (Radio Check)
80
Common Functions for Data Communications 38
Communicating via a Repeater (Repeater
Mode)
11
Communicating Without Using a Repeater (Talk
Around/ DMR Direct Mode)
9
COMMUNICATION SECURITY 116
COMMUNICATIONS IN AN EMERGENCY 93
Conditions to Activate the Scan (List Scan) 138
Conditions to Activate the Scan (Multi-Zone
Scan)
143
Conditions to Activate the Scan (Single Scan) 136
Conditions to Resume the Scan (List Scan) 138
Conditions to Resume the Scan (Multi-Zone
Scan)
143
Conditions to Resume the Scan (Single Scan) 136
Configuration Related to Transmission and
Reception in Emergency Mode
97
Configuring the Encryption Key Data Used for
Communications
119
CONTENTS i
CONTENTS BY PURPOSE xvi
INDEX
DMR FUNC (K, F)/Ver 2.20 169
CONTENTS INDEX
INDEX

Table of Contents

Other manuals for Kenwood NX-5200K3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood NX-5200K3 and is the answer not in the manual?

Kenwood NX-5200K3 Specifications

General IconGeneral
BrandKenwood
ModelNX-5200K3
CategoryTransceiver
LanguageEnglish

Related product manuals