Preventing the Functions Working with Group Call Reception from Activating (Call
Alert Inhibit (Group Calls Only))
Call Alert Inhibit (Group Calls only) is the function that disables the Alert Tone, Selective Call Alert LED, Horn Alert,
Vibrator and Caller ID Stack functions when the transceiver receives a Group Call.
Use
of this function prevents specific functions from activating as follows even if these functions are enabled or configured
to be enabled when the transceiver receives a Group Call.
0
Alert Tone
The following Alert Tones do not sound from the transceiver even if the transceiver receives a Group Call.
0
Alert Tone (Group Call List)
0
Group Call (Alert Tone) (Conventional)
0
Selective Call Alert LED
A Selective Call Alert LED does not blink even if the transceiver receives a Group Call.
0
Horn Alert (Mobile only)
The headlight of the vehicle connected to Horn Alert does not light up and the horn is not sounded even when a Group
Call is received.
0
Vibrator (Portable only)
The Vibrator does not function even if the transceiver receives a Group Call.
0
Caller ID Stack
The Caller ID will not be stored in the transceiver stack memory even if the transceiver receives a Group Call.
Configuration using KPG-D1/ D1N
Configuring the Call Alert Inhibit (Group Calls only) to be enabled or disabled (
Transceiver Settings > DMR >
DMR Information > General)
Avoiding Receiving a Group Call during an Incoming Individual Call (Ignore Group
Call during Individual Call)
Ignore Group Call during Individual Call is the function that disables receiving of Group Calls while an Individual Call is
being received.
Use this function to assign priority to Individual Calls that are received.
Enabling this function disables receiving of Group Calls (including data communication) while the transceiver is receiving
an Individual Call and the Auto Reset Timer is counting down.
Note
0
The following types of Group Call can be received even when this function is enabled.
0
Group Call via All Group ID
0
Emergency Group Call
0
When this function is enabled, receiving of Unaddressed Call will also be disabled while receiving an Individual Call.
0
When this function is enabled, OVCM via receiving of Group Call will be deactivated while receiving an Individual Call.
(Refer to Causing Transceivers Other than the Transceiver of the Specified ID to Participate in a Conversation (Open
Voice Channel Mode).)
Configuration using KPG-D1/ D1N
Configuring Ignore Group Call during Individual Call to be enabled or disabled (
Transceiver Settings > DMR >
DMR Information > General)
1 DMR CONVENTIONAL SYSTEM
1.7 Making a Group Call
DMR FUNC (K, F)/Ver 2.20 35
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
