Note
0
Busy Channel Lockout cannot
be activated in Emergency Mode. However, when “Interrupt CALL” is configured for In-
call Busy Channel Lockout, the configuration of In-call Busy Channel Lockout and Busy Channel Lockout will
become “Interrupt CALL” and “No” respectively in the Emergency Mode.
Configuration using KPG-D1/ D1N
0
Configuring Busy
Channel Lockout (DMR)/ In-call Busy Channel Lockout (Personality) (
Transceiver Settings
> Personal > Personality > DMR Conventional > DMR)
0
Configuring Busy Channel Lockout (DMR)/ In-call Busy Channel Lockout (Channel Edit) ( Transceiver
Settings > Zone/Channel > Channel Edit > DMR Conventional > DMR)
Using a Channel Being Used by Other Parties (BCL Override)
BCL Override is the function to transmit on a busy channel even if Busy Channel Lockout is activated and transmission
is restricted.
Operating the transceiver
1
Press the PTT switch while transmission is restricted by Busy Channel Lockout.
2
Release the PTT switch, then press the PTT switch again within 500 ms.
Busy Channel Lockout is temporarily disabled, and the transceiver starts transmitting.
Note
This function also works while the transceiver is transmitting using the VOX function. For a transmission using VOX, Busy
Channel
Lockout is temporarily disabled and the transceiver can transmit if audio is input within 500 ms after audio input
terminates.
Configuration using KPG-D1/ D1N
Configuring BCL
Override to be enabled or disabled (
Transceiver Settings > Personal > Personal Features > DMR
Conventional > General)
1 DMR CONVENTIONAL SYSTEM
1.1 Initiating Voice Communications (Basic Transmission and Reception)
DMR FUNC (K, F)/Ver 2.20 8
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
