MRS-BA-defsi-0410 110
4.5.2.4 Setting method name
• METHOD
METHOD ttt... Enter the name for the method
4.5.3 Starting weight
• SET
TARGET
WEIGHT
WEIGHT CHECK ON/OFF
Switch check on/off
NOMINAL
5.000
g
UPPER LIMIT 6.000 g
LOWER LIMIT
4.000 g
Enter nominal weight
Define upper limit
Define lower limit
With the aid of the «TARGET WEIGHT», you can weigh the sample
exactly to check that it matches a defined reference value
plus/minus permissible deviations.
"+", "–" and «
» are active in the display.
If «
» lights up, this indicates that the measurement lies within
the defined tolerances, and the drying process can commence. If
the sample weight lies outside the starting weight tolerance, the
drying process cannot be activated. In this case the starting weight
tolerances are displayed on the screen as an error message.
4.5.4 Units
• UNIT
UNIT 100-0%
0-100%
ATRO 100-999%
ATRO 0-999%
G/KG
RESIDUAL WEIGHT
WEIGHT LOSS
BALANCE WEIGHT
The unit of the measurement results printed in the report can be
selected in the «UNIT» menu option. The defined unit is also used
to print out interim values. The unit of measurement for the printout
can only be changed before, and not during, a measurement.
The unit selected is also used as the display unit, although it can
also be adjusted during and after the measurement . (see chapter
4.6.3"The change key")
To Next Page
Loading...
Need help?
General
