Calibration Procedures 4
Keysight 33210A Service Guide 57
Introduction
This chapter contains procedures for verification of the instrument's performance
and adjustment (calibration). The chapter is divided into the following sections:
– Keysight Technologies Calibration Services on page 58
– Calibration Interval on page 58
– Adjustment is Recommended on page 59
– Time Required for Calibration on page 60
– Automating Calibration Procedures on page 61
– Recommended Test Equipment on page 62
– Test Considerations on page 63
– Performance Verification Tests on page 64
– Internal Timebase Verification on page 68
– AC Amplitude (high-impedance) Verification on page 69
– Low Frequency Flatness Verification on page 71
– 0 dB Range Flatness Verification on page 72
– +10 dB Range Flatness Verification on page 74
– +20 dB Range Flatness Verification on page 76
– Calibration Security on page 78
– Calibration Message on page 80
– Calibration Count on page 81
– General Calibration/Adjustment Procedure on page 82
– Aborting a Calibration in Progress on page 83
– Sequence of Adjustments on page 84
– Self-Test on page 85
– Frequency (Internal Timebase) Adjustment on page 86
– Internal ADC Adjustment/Self Calibration on page 88
– Output Impedance Adjustment on page 90
To Next Page
