Keysight Technologies 33210A - Recommended Test Equipment

4 Calibration Procedures
62 Keysight 33210A Service Guide
Recommended Test Equipment
The test equipment recommended for the performance verification and
adjustment procedures is listed below. If the exact instrument is not available,
substitute calibration standards of equivalent accuracy.
Instrument Requirements Recommended Model
Use
[a]
Digital Multimeter
(DMM)
ac volts, true rms, ac coupled
accuracy: ±0.02% to 1 MHz
dc volts
accuracy: 50 ppm
resolution: 100 μV
Resistance
Offset-compensated
accuracy: ±0.1Ω
Keysight 3458A Q, P, T
Power Meter 100 kHz to 100 MHz
1 μW to 100 mW (–30 dBm to +20 dBm)
accuracy: 0.02 dB
resolution: 0.01 dB
Keysight E4418B Q, P, T
Power Head 100 kHz to 100 MHz
1 μW to 100 mW (–30 dBm to +20 dBm)
Keysight 8482A Q, P, T
Attenuator –20 dB Keysight 8491A Opt 020 Q, P, T
Frequency Meter accuracy: 0.1 ppm Keysight 53131A Opt 010 (high stability) Q, P, T
Oscilloscope
[b]
500 MHz
2 Gs/second
50Ω input termination
Keysight 54831B T
Adapter N type (m) to BNC (m) N type (m) to BNC (m) Q, P, T
Cable BNC (m) to dual-banana (f) Keysight 10110B Q, P, T
Cable (2 required) Dual banana (m) to dual banana (m) Keysight 11000-60001 Q, P, T
Cable RG58, BNC (m) to dual banana Keysight 11001-60001 Q, P, T
Cable RG58, BNC (m) to BNC (m) Keysight 8120-1840 Q, P, T
[a] Q = Quick Verification P = Performance Verification T = Troubleshooting
[b] An oscilloscope is not required for calibration, only for troubleshooting.