Keysight Technologies E5260 Series

Keysight E5260/E5270 Programming Guide, Edition 4 3- 37
Programming Examples
Quasi Pulsed Spot Measurements
Quasi Pulsed Spot Measurements
To perform quasi-pulsed spot measurements, use the following commands.
Function Command Parameters
Enables channels CN [chnum ... [,chnum] ... ]
Disables channels CL [chnum ... [,chnum] ... ]
Sets filter ON/OFF [FL] mode[,chnum ... [,chnum] ... ]
Sets series resistor ON/OFF [SSR] chnum[,mode]
Sets integration time
(Keysight E5270B can use
AAD/AIT instead of AV.)
[AV] number[,mode]
[AAD] chnum[,type]
[AIT] type,mode[,N]
Sets detection interval [BDM] interval[,mode]
Sets timing parameters [BDT] hold,delay
Sets quasi-pulsed source BDV chnum,range,start,stop[,comp]
Forces constant voltage DV, TDV chnum,vrange,output
[,comp[,polarity[,irange]]]
Forces constant current DI, TDI chnum,irange,output
[,comp[,polarity[,vrange]]]
Sets voltage measurement
range
[RV] chnum,range
Sets current measurement
range
[RI] chnum,range
[RM] chnum,mode[,rate]
Selects measurement mode MM 9[,chnum]
Sets SMU operation mode [CMM] chnum,mode
Executes measurement XE