Keysight Technologies E5260 Series

4- 68 Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Reference
30 : Returns the filter ON/OFF status:
FL0 [off ch[,off ch . . . [,off ch] . . . ];
FL1 [on ch[,on ch . . . [,on ch] . . ] <CR/LF^EOI>
If all modules are Filter OFF, the query response is:
FL0<CR/LF^EOI>
If all modules are Filter ON, the query response is:
FL1<CR/LF^EOI>
31 : Returns the parameter values of the TM, AV, CM, FMT, and MM
commands:
TM trigger mode;AV number[,mode];CM auto calibration mode;
FMT
output data format,output data mode
[;MM
measurement mode[,chnum[,chnum...[,chnum]...]]]
<CR/LF^EOI>
32 : Returns the measurement ranging status:
RI chnum,Irange;RV chnum,Vrange
[;RI chnum,Irange;RV chnum,Vrange]
:
[;RI
chnum,Irange;RV chnum,Vrange]<CR/LF^EOI>
33 : Returns the staircase sweep measurement settings:
WM automatic sweep abort function,output after sweep;
WT
hold time,delay time[,step delay time[,S trig delay[,M trig delay]]]
[;WV
chnum,mode,range,start,stop,nop[,Icomp [,pcomp]]] or
[;WI
chnum,mode,range,start,stop,nop[,Vcomp[,pcomp]]]
[;WSV
chnum,range,start,stop[,Icomp[,pcomp]]] or
[;WSI
chnum,range,start,stop[,Vcomp[,pcomp]]]<CR/LF^EOI>
34 : Returns the pulsed source settings:
PT hold time,pulse width[,pulse period[,trig delay]]
[;PV chnum,output range,base voltage,pulse voltage [,Icomp]] or
[;PI
chnum,output range,base current,pulse current [,Vcomp]]
[;PWV
chnum,mode,range,base,start,stop,nop[,Icomp]] or
[;PWI
chnum,mode,range,base,start,stop,nop[,Vcomp]]<CR/LF^EOI>
35 to 36 : Not used.