Keysight Technologies E5260 Series

Keysight E5260/E5270 Programming Guide, Edition 4 4- 135
Command Reference
Command Reference
WNU?
The WNU? query command returns the number of sweep steps specified by the
sweep command (WI, WV, PWI or PWV), and stores the results in the output data
buffer (query buffer).
Execution
Conditions
If you want to know the number of steps for a pulsed sweep, you must execute an
“MM 4” command before using this command, otherwise the number of steps for
the staircase sweep is reported.
Syntax WNU?
Query Response number of sweep steps<CR/LF^EOI>
Example
Statement
OUTPUT @E5270;"WNU?"
ENTER @E5270;A