Keysight E5260/E5270 Programming Guide, Edition 4 1- 49
Programming Basics
Programming Tips
• If you reuse the built-in IBASIC programs:
• Change the GPIB address.
• Remove the statements to use the built-in flexible disk drive.
Table 1-7 FLEX Commands Unsupported
Category Command
Control mode :PAGE, US, US42
Measurement mode VM, VMD
Staircase/pulsed sweep source setup ESC
Sampling source setup MCC, MI, MP, MSC, MV
Quasi-static CV measurement setup QSL, QSM, QSR, QST, QSV, QSZ, QSZ?
PGU control POR, SPG, SPP, SRP
Stress source setup STC, STI, STM, STP, STT, STV
Measurement setup MT
Integration time SIT, SLI
Measurement execution TI?, TTI?, TTV?, TV?
Time stamp TSQ?
Output data RMD?
Abort/pause/wait *WAI
Zero offset cancel GOC, SOC
SMU/PGU selector SSP
R-box RBC
External trigger STG
Network operation CLOSE, OPEN, PRN, RD?, SDSK, SPL,
SPR, WR
Status byte *CLS, *ESE(?), *ESR?
Query CMD?, *OPT?, :SYST:ERR?
To Next Page
Loading...
