2- 14 Keysight E5260/E5270 Programming Guide, Edition 4
Remote Mode Functions
Measurement Modes
NOTE The WSV command sets the sweep voltage, and the WSI command sets the sweep
current. You can use the same output mode (voltage or current) as the primary
sweep. The start and stop values must have the same polarity for log sweep.
To Stop Sweep
Output
An automatic abort function is available. Refer to “Automatic abort Function” on
page 2-23.
Even if the automatic abort function is disabled, the E5260/E5270 automatically
stops measurement if power compliance is enabled for the sweep source and the
power compliance or an automatic abort condition is detected.
To Next Page
Loading...
Need help?
General
