94 Keysight EXG and MXG X-Series Signal Generators User’s Guide
Optimizing Performance for All Models
Using the USB Pass Through Commands
4. Sending additional
SCPI commands.
If you are sending a
query, go to step 5.
Else, repeat steps 4 and
or 5 as needed.
a. Enter:
:SYSTem:PMETer:PASSt
hrough "SCPI
command"
Where "SCPI command" is any SCPI pass through
command. Refer to Table 5-1 on page 93.
5. Sending additional
SCPI queries.
If you are sending a
command, go to step 4.
Else, repeat steps 4 and
or 5as needed.
a. Enter:
:SYSTem:PMETer:PASSt
hrough? “*IDN?”
The power sensor model and serial number should be
returned.
Step Substeps Results/Notes
To Next Page
Loading...
