164 Keysight Agile Signal Generator Service Guide
Safety and Regulatory
General Safety Considerations
The following safety notes are used throughout this manual. Familiarize
yourself with each of the notes and its meaning before operating this
instrument.
The following safety notes apply specifically to signal generators. These notes
also appear in other chapters of this service guide as required.
Warning denotes a hazard. It calls attention to a condition or situation that could result in
personal injury or loss of life. Do not proceed beyond a warning until you fully understand the
indicated conditions or situations.
Caution calls attention to a condition or situation that could result in damage to or destruction of
the signal generator, or in the loss of a user’s settings or data. Do not proceed beyond a caution
until you fully understand the indicated conditions.
These servicing instructions are for use by qualified personal only. To avoid electrical shock, do
not perform any servicing unless you are qualified to do so.
The opening of covers or removal of parts is likely to expose dangerous voltages. Disconnect the
product from all voltage sources before starting to open.
The detachable power cord is the instrument disconnecting device. It disconnects the main
circuits from the main supply before other parts of the instrument. The front panel switch is only
a standby switch and is not a LINE switch (disconnecting device).
The power cord is connected to internal capacitors that may remain live for 5 seconds after
disconnecting the plug from its power supply.
This is a Safety Class 1 Product (provided with a protective earthing ground incorporated in the
power cord). The mains plug shall only be inserted in a socket outlet provided with a protective
earth contact. Any interruption of the protective conductor inside or outside of the product is
likely to make the product dangerous. Intentional interruption is prohibited.
To Next Page
Loading...
Need help?
General
