Keysight 34420A - Page 105

Features and Functions 3
Keysight 34420A User’s Guide 101
– Front Panel operation (continued)
To set the delay to 0 seconds, select the “parameter” level of the TRIG DELAY
command. Move the flashing cursor to the “units” location on the right side of
the display. Press until ZERO DELAY is reached, then press .
– To select the automatic trigger delay, select the “parameter” level of the TRIG
DELAY command. Move the flashing cursor to the “units” location on the right
side of the display. Press until AUTO DELAY is reached, then press .
– Remote operation:
You can use the following command to set the trigger delay.
TRIGger:DELay {<seconds>|MIN|MAX}
You can use the following command to set an automatic trigger delay.
TRIGger:DELay:AUTO {OFF|ON}
∧
Enter
ZERO DELAY
∧
Enter
AUTO DELAY