Features and Functions 3
Keysight 34420A User’s Guide 119
Programming Language Selection
You can select one of two languages to program the meter from the selected
remote interface. The programming language is SCPI when the meter is shipped
from the factory.
– Select one of the following: SCPI or 181 (Keithley).
– The language selection is stored in non-volatile memory, and does not change
when power has been off or after a remote interface reset.
– There are certain restrictions to be aware of when you are selecting the
interface language (see also “Remote Interface Selection” on page 115). The
Keithley 181 language is not supported on the RS-232 interface.
– Front Panel operation: set the programming language under the 5: LANGUAGE
command in the I/O menu.
See also “To Select the Programming Language” on page 213.
– Remote operation: use the following command to set the language:
SYStem:LANGuage <language>
To Next Page
Loading...
