Remote Interface Reference 4
Keysight 34420A User’s Guide 213
To Select the Programming Language
You can select one of three language to program the meter from the selected
remote interface. The language is SCPI when the meter is shipped from the
factory. The language setting is stored in non-volatile memory and does not
change with power off or reset. See also “Programming Language Selection” on
page 119.
1 Turn on the front-panel menu.
2 Move across to the I/O MENU choice on this level.
3 Move down a level and then across to the LANGUAGE command.
4 Move down to the “parameter” level to select the language.
Choose from one of the following: SCPI or KEITHLEY:181
5 Save the change and turn off the menu.
To Next Page
Loading...
