Front-Panel Operation 2
Keysight 34420A User’s Guide 57
To Store Minimum and Maximum Readings (Stats)
You can store the minimum and maximum readings during a series of
measurements. The following discussion shows how to read the minimum,
maximum, average, peak-to-peak, standard deviation, and reading count.
– You can use stats with any function. When you change functions, stats
operation is disabled.
– Changing input channels or selecting Scan does not disable stats. The stored
readings, however, are not marked as to the input channel.
– After enabling stats, you can read the stored minimum, maximum, average,
standard deviation, peak-to-peak, and count by pressing
(Menu
Recall). This takes you to the “STATS” command in the MATH MENU (only if
stats is enabled). Go down to the “parameter” level , and then read the
values by pressing or .
– After reading the stored value, pressing
(Menu On/Off) returns to
the measurement display and continues stats operations.
– The stored values are cleared when you turn stats on, turn off the power, or
perform either a remote interface reset or preset.
To Next Page
Loading...
