Keysight 34420A - To Set the GPIB Address

Remote Interface Reference 4
Keysight 34420A User’s Guide 205
To Set the GPIB Address
Each device on the GPIB (IEEE-488) interface must have a unique address. You
can set the meter’s address to any value between 0 and 31. The address is set to
“22” when the meter is shipped from the factory. The address is displayed on the
front panel when you turn on the meter.
1 Turn on the front-panel menu.
2 Move across to the I/O MENU choice on this level.
3 Move down a level to the GPIB ADDR command.
4 Move down to the “parameter” level to set the address.
Use the left/right and down/up arrow keys to change the address.
Shift
∧
On/Off
A: MEAS MENU
∧
∧
F: I/O MENU
∧
1: GPIB ADDR
∧
^
22 ADDR