4 Remote Interface Reference
204 Keysight 34420A User’s Guide
TALK ONLY for Printers
You can set the meter’s GPIB address to “31” which is the talk only mode. In this
mode, the meter can output readings directly to a printer without being addressed
by a bus controller. Address 31 is not a valid address if you are operating the
meter from the GPIB interface with a bus controller.
If you select the RS-232 interface and then set the GPIB address to the talk only
address (31), the meter will send readings over the RS-232 interface when in the
local mode.
To Next Page
Loading...
