Remote Interface Reference 4
Keysight 34420A User’s Guide 131
Remote Interface Reference
This chapter is divided into the following sections:
– “Command Summary” on page 133
– “Simplified Programming Sequence” on page 142
– “MEASure? and CONFigure Defaults” on page 143
– “Setting the Function, Range, and Resolution” on page 152
– “Selecting the Input Channel” on page 155
– “Special Resistance Measurement Commands” on page 156
– “Temperature Measurement Commands” on page 157
– “Null (Relative) Commands” on page 160
– “Input Filter Commands” on page 162
– “Math Operation Commands” on page 164
– “Triggering” on page 167
– “Triggering Commands” on page 170
– “Chart Output (Analog Out) Commands” on page 172
– “System-Related Commands” on page 173
– “The SCPI Status Model” on page 175
– “Status Reporting Commands” on page 186
– “Calibration Commands” on page 189
– “RS-232 Interface Configuration” on page 191
– “RS-232 Interface Commands” on page 197
– “An Introduction to the SCPI Language” on page 198
– “Input Message Terminators” on page 201
– “Output Data Formats” on page 202
– “Using Device Clear to Halt Measurements” on page 203
– “TALK ONLY for Printers” on page 204
– “To Set the GPIB Address” on page 205
– “To Select the Remote Interface” on page 207
To Next Page
Loading...
