Keysight 34420A - Page 147

Remote Interface Reference 4
Keysight 34420A User’s Guide 143
MEASure? and CONFigure Defaults
Setting SCPI Command System Defaults Used
Common
to all
Functions
Input Channel
Digital Filter
Digital Filter Precharge
Analog Filter
Trigger Source
Trigger Delay
Trigger Count
N Samples
Math
Readings Store
Display (On or Off)
ROUTe:TERMinals
INPut:FILTer
INPut:FILTer
INPut:FILTer
TRIGger:SOURce
TRIGger:DELay
TRIGger:COUNt
SAMPle:COUNt
CALCulate
DATA:FEED RDG_STORE
DISPlay
Channel 1
Off
Last value set
Off
Immediate
Auto
1
1
Off
"CALC"
On
Specific
To Each
Function
Integration Time (NPLC)
Range
Null
<resolution>
<range>
SENSe: <function> :NULL
(10 plc)
Autorange
Off
Resistance
Specific
Offset Compensated W
Voltage Limited W
Low Power W
SOURce:FRESistance:OCOMPensated
SOURce:FRESistance:VOLTage:LIMit
SOURce:FRESistance:POWer:LIMit
Off
Last value set
Last value set
Temperature
Specific
Transducer
Probe Type
RTD type and resistance
SENSe:TEMPerature:TRANsducer
SENSe:TEMPerature:TRANsducer
SENSe:TEMPerature:TRANsducer
Last probe set
Last type set
Last type set
NOTE
The MEASure? and CONFigure commands use default parameters for volatile
memory parameters. Non-volatile memory parameters are not modified and the
MEASure? or CONFigure commands use parameters in memory. See page 126.
For example, the temperature units last set are stored in non-volatile memory
and are not changed by a MEASure? or CONFigure command.