Remote Interface Reference 4
Keysight 34420A User’s Guide 185
register to determined if the digital filter ever settled. The digital filter count can
be reset based upon input signal levels. See page 70.
Bit Definitions — Operational Status Register
The operational status event register is cleared when:
– You execute a *CLS (clear status) command.
– You query the event register using STATus:OPERation:EVENt?.
The operational status enable register is cleared when:
– You turn on the power (*PSC does not apply).
– You execute the STATus:PRESet command.
– You execute the STATus:OPERation:ENABle 0 command.
If you need to know the digital filter state for a given measurement, use the
condition register (STATus:OPERation:CONDition?). This bit changes with each
measurement. Changes to this bit are latched in the operational status event
register and so the event register bit only indicates if the filter ever settled.
Bit Decimal Value Definition
0 Not Used
256
Always set to 0
1 ##
#
7
8 Filter Settled Digital filter is settled.
9 Not Used Always set to 0.
# ##
15
To Next Page
Loading...
