Keysight 3458A - SLOPE [slope]; SMATH [register][,number]; SRQ

Command Summary
Keysight 3458A Quick Reference Guide 49
Keysight 3458A Quick Reference Guide 49
type = ANA (1), RNDM (2), SYNC (3)
Power-on type = ANA.
Default type = ANA.
SLOPE [slope]
SLOPE is used in conjunction with the LEVEL
command and specifies which slope of the signal
will be used by the level-detection circuitry.
slope = NEG (0), POS (1)
Power-on slope = POS.
Default slope = POS.
SMATH [register][,number]
Store Math. Places a number in a math register.
register = DEGREE (1), LOWER (2), MAX (3),
MEAN (4), MIN (5), NSAMP (6), OFFSET (7),
PERC (8), REF (9), RES (10), SCALE (11),
UPPER (13), HIRES (14), PFAILNUM (15)
Default register = DEGREE.
number: The number parameter is the value to be
placed in the register.
Default number = last reading.
SRQ
Service Request. Sets bit 2 in the multimeter’s
status register. If bit 2 is enabled to assert SRQ
(RQS 4 command), executing the SRQ command
will set the GPIB SRQ line.