Chapter 3 115
Instrument Messages
Condition Errors 201 to 299, Signal Integrity
219 Signal Too Noisy E NADC & PDC: The valid EVM measurement cannot
be performed, because the input signal is too noisy.
GSM & EDGE: In a GSM measurement, indicates that
a burst could not be found in a signal that appears
noisy.
221 Slot Error E
221 Slot Error; No idle
slot found
E No valid idle slot found in captured data, or no idle slot
found in captured interval. Synchronization may
succeed and pilot found when this message is issued,
but no results are included in peak/average calculation.
221 Slot error;No active
slot found
E No valid active slot found in captured data, or no active
slot found in captured interval. Synchronization may
succeed and pilot found when this message is issued,
but no results are included in peak/average calculation.
223 unused bit10 is set E
225 unused bit11 is set E
227 unused bit12 is set E
229 unused bit13 is set E
231 unused bit14 is set E
To Next Page
Loading...
