36 Chapter 1
Overview
After an Instrument Repair
After an Instrument Repair
If any instrument assemblies have been repaired or replaced, perform the related
adjustments and performance verification tests. These tests are done using the
N7814A Agilent X-Series Signal Analyzer Calibration Application Software.
Refer to Chapter 14 , “Post-Repair Procedures” for a list of post-repair adjustments
and performance tests based on which hardware has been changed.
Information regarding the N7814A Agilent X-Series Signal Analyzer Calibration
Application Software can be found at
http://www.agilent.com/find/calibrationsoftware
To Next Page
Loading...
