228 Chapter 13
Assembly Replacement Procedures
Tools you will need
Tools you will need
Figure 13-1 TORX Tool
Adjustments Tests after an instrument repair
Refer to Table 14-1 on page 280 for information about post-repair procedures. If
one or more instrument assemblies have been repaired or replaced, perform the
related adjustments and performance verification tests.
Description Agilent Part Number
TORX Hand Driver - Size T-10 8710-1623
TORX Hand Driver - Size T-20 8710-1615
9/16 inch nut driver 8720-0008
5/16 inch open-end wrench source locally
cable puller 5021-6773
To Next Page
Loading...
