Keysight N9041B - 3.6.4 BW; 3.6.4.1 Settings; Info BW

3 Spectrum Analyzer Mode
3.6 Power Stat CCDF Measurement
Prefilter Presets
Meas Mode Preset
SPEC BASIC OFF
WAV BASIC, WCDMA, WLAN, LTEAFDD, LTEATDD, 5GNR, VMA OFF
MON WCDMA, WLAN, LTEAFDD, LTEATDD, 5GNR, VMA OFF
RHO WCDMA OFF
CDP WCDMA OFF
PCON WCDMA OFF
EVMQ WCDMA OFF
CHP WCDMA, WLAN, LTEAFDD, LTEATDD, 5GNR, VMA, SA OFF
OBW WCDMA, WLAN, LTEAFDD, LTEATDD, 5GNR, VMA, SA OFF
ACP WCDMA, LTEAFDD, LTEATDD, 5GNR, VMA, SA OFF
SEM WCDMA, WLAN, LTEAFDD, LTEATDD, 5GNR, VMA, SA OFF
PST WCDMA, WLAN, LTEAFDD, LTEATDD, 5GNR, VMA, SA OFF
PVT WLAN, LTEAFDD, LTEATDD, 5GNR OFF
EVM WLAN, LTEAFDD, LTEATDD, 5GNR OFF
FLAT WLAN OFF
EVMM WLAN OFF
CEVM LTEAFDD, LTEATDD OFF
PAVT 5GNR, VMA OFF
DDEM VMA OFF
OFDM VMA OFF
SAN SA ON
HARM SA ON
3.6.4 BW
Opens the Bandwidth (BW) menu, which contains the Info BW control.
3.6.4.1 Settings
Contains basic bandwidth functions. It is the only tab under BW.
Info BW
Allows you to enter a frequency value to set the channel bandwidth that will be used
for data acquisition. When in Auto, it is set to the value that covers carriers set by
carrier configuration.
Remote
[:SENSe]:PSTatistic:BANDwidth <freq>
1182 Spectrum Analyzer Mode User's &Programmer's Reference