3 Spectrum Analyzer Mode
3.2 Swept SA Measurement
This means that when you have this switch on, performing Mode Preset causes the
Peak detector to be chosen, rather than the Normal detector, just like ESA.
Remote Command
:CONTrol:COMPatible:DETector ON | OFF | 1 | 0
:CONTrol:COMPatible:DETector?
Example
:CONT:COMP:DET ON
ON means exhibit ESA detector behavior
Preset Unaffected by Mode Preset. Set to OFF by Restore Mode Defaults
State Saved Saved in State
*RST
In older HP/Agilent/Keysight Spectrum Analyzers, sending *RST (to preset the
analyzer) puts the analyzer in Continuous sweep mode. To be compliant with the
IEEE-488.2 specification, X-Series instruments put the instrument into Single sweep
mode on *RST.
For backwards compatibility, when the *RST switch in the Legacy Compatibility
menu is ON, the *RST command puts the instrument into Continuous sweep mode.
Remote Command
:CONTrol:COMPatible:RST ON | OFF | 1 | 0
:CONTrol:COMPatible:RST?
Example
:CONT:COMP:RST ON
ON means exhibit pre-X-series *RST behavior
Preset Unaffected by Mode Preset. Set to OFF by Restore Mode Defaults
State Saved Saved in State
3.2.8.5 Tune & Listen
Contains controls to turn the demod function on and off and select modulation type
and configure the demod bandwidth. This tab only appears if N9063C Analog
Demod Mode, N6141C Mode, or Option EMC is installed and licensed.
Does not appear in instruments that do not contain a speaker, such as VXT, EXM,
UXM and CXA-m.
When the function is ON (set to AM, FM, or ΦM), the demodulated signal is fed to the
instrument’s speaker. Muting and volume control functions are done through the
standard Windows speaker volume control interface.
Demod Type
Sets the type of Demod to be performed for the Tune & Listen function.
428 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
