3 Spectrum Analyzer Mode
3.8 Spurious Emissions Measurement
Adjust Atten for Min Clipping
Sets the combination of mechanical and electronic attenuation and gain based on
the current measured signal level so that clipping will be at a minimum.
This is an immediate action function, that is, it executes once, when the control is
pressed.
The algorithms that are used for the adjustment are documented under "Pre-Adjust
for Min Clipping" on page 1964.
Remote Command
[:SENSe]:POWer[:RF]:RANGe:OPTimize IMMediate
Example
:POW:RANG:OPT IMM
Notes Executing Adjust Atten for Min Clipping initiates the measurement
Dependencies Does not appear in the Swept SA, RTSA, Monitor Spectrum and Complex Spectrum measurements
Appears in the Waveform measurement in BASIC and 5G NR Modes
Adjust Atten
Allows you to select;
–
Electric attenuator only
–
Combination of Electric attenuator and Mechanical attenuator
when [:SENSe]:POWer[:RF]:RANGe:OPTimize IMMediate is executed.
Remote Command
[:SENSe]:POWer[:RF]:RANGe:OPTimize:TYPE EONLy | COMBined
[:SENSe]:POWer[:RF]:RANGe:OPTimize:TYPE?
Example
:POW:RANG:OPT:TYPE EONL
:POW:RANG:OPT:TYPE?
Dependencies Does not appear in the Swept SA, RTSA, Monitor Spectrum and Complex Spectrum measurements
Appears in the Waveform measurement in BASIC and 5G NR Modes
Preset
COMBined
State Saved Saved in instrument state
Pre-Adjust for Min Clipping
If this function is ON, it applies the adjustment described under "Adjust Atten for Min
Clipping" on page 1963 each time a measurement restarts. Therefore, in Continuous
measurement mode, it only executes before the first measurement.
Spectrum Analyzer Mode User's &Programmer's Reference 1377
To Next Page
Loading...
